TRex Metal Tank

T_REX TANK является цельнометаллической танковой платформой, которая предназначена для вездеходных роботов. Все шесть нижних колес имеют независимую подвеску, чтобы помочь улучшить тягу и поглощать удары. Высокий дорожный просвет позволяет T"REX двигаться по труднопроходимой местности.

Introduction:
The T_REX TANK is an all-metal tank chassis designed for all-terrain robot projects. All six
lower wheels have independent suspension to help improve traction and absorb shock.
High ground clearance allows the T_REX to handle very rough terrain.

Removing the covers:
The front and top covers are held in place with spring catches mounted between the
wheels. To release the front cover, slide the front catch releases on both sides towards the
back. The front cover should then lift up so it can be easily opened.
To release the top cover, slide the rear catch releases on both sides to the back. The top
cover will then lift up slightly so it can be easily removed.
To lock these covers back in place, push down firmly until you hear the catches _click_.
Please note that the top cover can only go in one way.

Power:
There is plenty of room inside for batteries, the T_REX controller and a development board.
The T_REX has 12V motors so a 3S LiPo, 5000mAh or better is recommended. The T_REX
controller includes a switch-mode power supply that can efficiently supply 6V for servos
and 5V for a development board.Electrical noise and RF shielding:
The aluminium body will block electrical noise and radio signals so it is recommended that
all radio transmitters / receivers, GPS and compass modules are mounted on top of the
chassis.

Removable sensor panel:
The front sensor panel can be removed to make it easy to drill mounting holes for sensors.
This panel can also be reversed so that sensors can be mounted further back. If you have
a 3D printer you may prefer to remove this panel and replace it with a custom front panel.
Maintenance:
The body is aluminium, the gears, tracks, suspension struts and wheels are die cast zinc.
These metals offer good corrosion resistance so no maintenance for these parts is
required.
The idler wheels can be easily removed for cleaning by removing the circlip on the shaft.
Be careful when removing these as they are under spring tension and may shoot off.
The idler wheels have brass bushes that require minimum maintenance. A dry lubricant
should be used for the idler wheels and gearbox.

Dimensions:
Width: 235mm
Length: 350mm
Body Height: 60mm
Ground Clearance: 70mm
Total Height: 130mm
Weight: 3.6Kg
Motor Specifications:
Voltage: 12V
Nominal Current: 3A
Stall Current: 11A

Платформы и колёса TRex Metal Tank. Описание в формате PDF

------------------
УЛ1269134:25274