The DaVinci is an Arduino compatible board with several unique features to facilitate its use in robotics.
The DaVinci includes a 2 pin screw terminal for use with batteries as the primary power source.
It also includes a jumper to set RTS or DTR as the reset signal.
In addition it includes a low profile USB connector.
This prevent the USB connector from interfering with over sized shields.
The DaVinci also includes dual mount pattern which makes it functional with existing projects and compatible with mounting in robotics.

Downloads
The DaVinci
The new DaVinci is a 100% Arduino compatible board.
It was designed to support standard shields and work in robotics systems.
The main features are the improved regulators, low profi le capacitors, low profile USB connector and screw terminals for power.
The low profile parts prevent interference with all shields.
The additional mount pattern fits a standard mount for currently available robots.
The DaVinci ships with a pre-programmed socketed Atmel.
The reset control can be set by jumper to DTR or RTS control.
Standard TX , RX and ON leds are on board.
Improved regulators were used to decrease drop out voltages.
The TX / RX from the Arduino can be removed from circuit to isolated the Arduinos only UART.
Documentation
Arduino is a 100% open source solution.
Hardware and software.
In keeping with that tradition we have included the schematics to this board at the end of the data sheet.
All programming documentation is supplied by the Arduino community.
The Arduino IDE and programming guides can be downloaded from http:///www.arduino.cc

Контроллеры The DaVinci Arduino Compatible. Описание в формате PDF

------------------
УЛ813451:1823