Драйвер электромотора L293D для Arduino Драйвер моторов L293D для ARDUINO Duemilanove, Mega, UNO, Leonardo.

L293D is a monolithic integrated, high voltage, high current, 4-channel driver.
Basically this means using this chip you can use DC motors and power supplies of up to 25 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what"s known as a type of H-Bridge.

The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.

2 interface for 5V Servo connected to the Arduino"s high-resolution dedicated timer - no jitter.
Can drive 4 DC motors or 2 stepper motors or 2 Servo.
Up to 4 bi-directional DC motors with individual 8-bit speed selection.
Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 25V DC.
Pull down resistors keep motors disabled during power-up.
reset button.
2 external terminal power interface, for seperate logic/motor supplies.
Tested compatible for Arduino Mega, Diecimila & Duemilanove.

Управление коллекторными электромоторами Motor Drive Shield L293D for Arduino. Описание в формате PDF

------------------
УЛ1187048:782

Купившие этот товар также заказали:

Контроллеры Arduino Mega 2560 R3 [not original]

Механизм RA039. Редуктор с моторами (2 вала)

BB-801. Макетная плата для монтажа без пайки

Комплект цветных монтажных перемычек BBJ-65 для макетных плат без пайки (беспаечная макетная плата)

Модуль RA007. Датчик присутствия HC-SR501

H571-05520. Гибридный шаговый двигатель